Start by changing the pull-up resistor. 56kΩ is far too high for a 110Ω sender. Try a 100Ω resistor instead, this will significantly improve your voltage resolution. Also, take a look at this topic: Calibrating fuel level
Related topics
| Topic | Replies | Views | Activity | |
|---|---|---|---|---|
| Calibrating fuel level | 8 | 736 | March 15, 2025 | |
| Fuel sensor calibration - Non linear | 4 | 104 | January 27, 2026 | |
| Honda EP3 analogue fuel sender with 120OHM - input table | 9 | 268 | April 6, 2025 | |
| Setting fuel level from previous dash settings? | 8 | 268 | April 23, 2025 | |
| Fuel Level Sensor | 4 | 1234 | September 30, 2024 |