# EMU classic and VAG VR5 first start

**URL:** <https://community.ecumaster.com/t/emu-classic-and-vag-vr5-first-start/3890>\
**Category:** EMU BLACK / CLASSIC\
**Created:** [June 18, 2025, 9:09pm UTC](https://community.ecumaster.com/t/emu-classic-and-vag-vr5-first-start/3890 "2025-06-18T21:09:14Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![M3nta](https://avatars.discourse-cdn.com/v4/letter/m/dc4da7/32.png) [@M3nta](https://community.ecumaster.com/u/M3nta)\
**Post date:** [June 18, 2025, 9:09pm UTC](https://community.ecumaster.com/t/emu-classic-and-vag-vr5-first-start/3890/1 "2025-06-18T21:09:14Z")

</div>

Hello i have some problems with my setup. After many corrections my cars run, but i leave without saving changes and lost anything, now wont start.

Short info  
2.3l 5 cylinders  
COP from audi R8  
Bosch 627cc ev14  
4bar map (external mounted on intake manifold)  
TB drive with cable and TPS  
LSU 4.2  
Primary trigger VR  
Second trigger hall pulluped 10k

Crancking fuel 4-5ms  
VE table 42-44 kpa on idle 1100rpm  
This is the settings after firts i can see, but i am leave…

I am cheked with light gun and set ignition and cranchking anle 0°  
First trigger 8 - 4 - 1 - 0  
Trigger angle 50- 72- 90- 98  
Both trigger settings show timing correct with is the best. And i checked trought cranck sensor hole my TDC comes with 19tooth after missing

Some one help me.

---

<div class="post-metadata">

**Author:** ![M3nta](https://avatars.discourse-cdn.com/v4/letter/m/dc4da7/32.png) [@M3nta](https://community.ecumaster.com/u/M3nta)\
**Post date:** [June 22, 2025, 12:54pm UTC](https://community.ecumaster.com/t/emu-classic-and-vag-vr5-first-start/3890/2 "2025-06-22T12:54:14Z")

</div>

![forum pic](https://europe1.discourse-cdn.com/flex013/uploads/ecumaster/original/2X/5/5019343ea5028207e2224af6c62d2ede089bc6b5.jpeg)

Where is the wrong?