# Ford Scorpio Cosworth 24V 2.9 V6 (BOB) - ECU Master Black

**URL:** <https://community.ecumaster.com/t/ford-scorpio-cosworth-24v-2-9-v6-bob-ecu-master-black/6653>\
**Category:** GENERAL\
**Tags:** how-to\
**Created:** [October 14, 2026, 6:42am UTC](https://community.ecumaster.com/t/ford-scorpio-cosworth-24v-2-9-v6-bob-ecu-master-black/6653 "2026-10-14T06:42:14Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![dennisgsy](https://dub1.discourse-cdn.com/flex013/user_avatar/community.ecumaster.com/dennisgsy/32/7297_2.png) [@dennisgsy](https://community.ecumaster.com/u/dennisgsy)\
**Post date:** [October 14, 2026, 6:42am UTC](https://community.ecumaster.com/t/ford-scorpio-cosworth-24v-2-9-v6-bob-ecu-master-black/6653/1 "2026-10-14T06:42:14Z")

</div>

Hi everyone,

I’m currently planning an engine management upgrade for my 1982 Ford Capri Mk3, which is fitted with a Ford Scorpio Cosworth 2.9 V6 24V (BOB) engine.

The engine currently runs on a MegaSquirt ECU with Ford EDIS6 ignition, and I’m planning to replace this setup with an **ECUMaster EMU Black** , incorporating sequential fuel injection and individual coil-on-plug ignition.

I’ve already purchased the EMU Black and six Bosch smart ignition coils, which have been successfully test-fitted to the engine.

I’m currently documenting the existing engine sensors, wiring and ancillary systems before progressing with the new wiring loom.

**I’d particularly like to hear from anyone who has installed an EMU Black on this engine** , or has experience configuring one for the Ford Cosworth 24V V6.

Some of the areas I’m investigating include:

- Crank and cam sensor compatibility and trigger configuration.

- Sequential injection and ignition setup.

- Idle air control valve configuration.

- Variable Inlet System (VIS) operation.

- Existing sensor compatibility and any recommended replacements.

- Knock sensor installation and configuration.

**Does anyone have a suitable base map or example EMU Black configuration for the naturally aspirated BOB engine?** Even a partially configured project would be a useful starting point.

My intention is to prepare and build as much of the wiring loom as practical myself, before having a specialist complete the installation, commissioning and mapping.

I’d be very interested to hear from anyone who has undertaken a similar conversion, particularly any lessons learned or potential pitfalls.

Many thanks in advance for any advice or information.

 ![IMG_3015.HEIC](https://europe1.discourse-cdn.com/flex013/uploads/ecumaster/original/2X/8/89efebfab1f56346c409ca482a8b08cab25b6089.jpeg)