# Help with basic setup please

**URL:** <https://community.ecumaster.com/t/help-with-basic-setup-please/5236>\
**Category:** GENERAL\
**Created:** [February 14, 2026, 5:45pm UTC](https://community.ecumaster.com/t/help-with-basic-setup-please/5236 "2026-02-14T17:45:42Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Tricky](https://avatars.discourse-cdn.com/v4/letter/t/d6d6ee/32.png) [@Tricky](https://community.ecumaster.com/u/Tricky)\
**Post date:** [February 14, 2026, 5:45pm UTC](https://community.ecumaster.com/t/help-with-basic-setup-please/5236/1 "2026-02-14T17:45:42Z")

</div>

Hi All,

I am new to the ECU master hardware and am just getting to the point of getting everything setup and could do with some help

My setup is:

EMU Black ECU, PMU 16, ADU 5 dash, GPS to CAN, Blink marine 4x2 Keypad

My challenge is getting the CAN key pad to activate functions on the PMU - I have setup the PMU, ECU, dash and GPS module on CAN 1 all at 1mbps, I have a separate CAN 2 network from the ADU 5 to a the CAN keypad - This is set to 500kbps

Is there a way to get the ADU 5 to relay a CAN message to the PMU in this setup to control outputs or do I also have to add the PMU on the CAN 2 network?

Any help would be greatly appreciated, also, is there any video showing the basics for the software, I am really starting from scratch and cannot even figure the software out

Thanks

---

<div class="post-metadata">

**Author:** ![Tricky](https://avatars.discourse-cdn.com/v4/letter/t/d6d6ee/32.png) [@Tricky](https://community.ecumaster.com/u/Tricky)\
**Post date:** [February 16, 2026, 9:43am UTC](https://community.ecumaster.com/t/help-with-basic-setup-please/5236/2 "2026-02-16T09:43:15Z")

</div>

I have resolved this, I just wired in the PMU to the CAN 2 network as well, no ideal why I didn’t do this first time around.