# Injector phase for 4cyl only crank sensor

**URL:** <https://community.ecumaster.com/t/injector-phase-for-4cyl-only-crank-sensor/3454>\
**Category:** GENERAL\
**Created:** [March 31, 2025, 12:29pm UTC](https://community.ecumaster.com/t/injector-phase-for-4cyl-only-crank-sensor/3454 "2025-03-31T12:29:31Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Moriaan1990](https://avatars.discourse-cdn.com/v4/letter/m/ac8455/32.png) [@Moriaan1990](https://community.ecumaster.com/u/Moriaan1990)\
**Post date:** [March 31, 2025, 12:29pm UTC](https://community.ecumaster.com/t/injector-phase-for-4cyl-only-crank-sensor/3454/1 "2025-03-31T12:29:31Z")

</div>

Hey,

im Realy desperate and need your help. i dont understand injector phase degree

Car is 2.0 16v Turbo firing order 1342

only crank sensor

dual coilpack

cylinder 1 and 4 are coil1  
cylinder 2 and 3 are coil 2

can somebody please tell me the settings for ignition and injector phase to make it work im realy struggeling

i use v2 and v3 software, so it doesnt matter please just tell me how, car always got wet sparkplugs and bangs at exhaust

i use trigger settings from old kms ecu that was installed bevore.

car runs one time,but i cant find the right settings anymore.

amd maybe what fuel settings for porsche 630 injectors.

please help me out i tried everything, engine is brand new and is tart killing it whit fuel flooding…

very best regards  
[lancia\_base\_stefan\_v1.emub3](https://community.ecumaster.com/uploads/short-url/q9ixWZikOt6hYOu57s7ZB7jJh0s.emub3) (62.0 KB)

---

<div class="post-metadata">

**Author:** ![shyam](https://avatars.discourse-cdn.com/v4/letter/s/dfb087/32.png) [@shyam](https://community.ecumaster.com/u/shyam)\
**Post date:** [April 11, 2025, 7:36pm UTC](https://community.ecumaster.com/t/injector-phase-for-4cyl-only-crank-sensor/3454/2 "2025-04-11T19:36:36Z")

</div>

Hi,  
There is major difference between v2 and v3 software in terms of setup  
how have you wired your injectors?  
Is:  
injector 1 from Cylinder 1  
Injector 2 from Cylinder 2  
Injector 3 from Cylinder 3  
Injector 4 from Cylinder 4

because from the table below the Injector 4 is set to Cylinder 2 and Injector 2 in cylinder 3 and injector 3 in cylinder 4…

could you also please attach a log file and scope log.

 ![image](https://europe1.discourse-cdn.com/flex013/uploads/ecumaster/original/2X/8/82b488e5ce9a769c749d640f6c6f8003f138e8af.png)

Please stick to one firmware version either v2 or v3. then it is possible to get somewhere with the issue.