# New software 3.044 available! **URL:** https://community.ecumaster.com/t/new-software-3-044-available/3156 **Category:** V3 SOFTWARE **Created:** [February 7, 2025, 10:29pm UTC](https://community.ecumaster.com/t/new-software-3-044-available/3156 "2025-02-07T22:29:20Z") **Posts on this page:** 1 **Showing post:** 36
### Author: ![jpbello07](https://avatars.discourse-cdn.com/v4/letter/j/85e7bf/32.png) [@jpbello07](https://community.ecumaster.com/u/jpbello07) #### Post date: [February 15, 2025, 4:59am UTC](https://community.ecumaster.com/t/new-software-3-044-available/3156/36 "2025-02-15T04:59:07Z")
You can use the Functions method for this. To do this, you can- Set Output to Virtual Action “Set Output Only” Create operator in which- If Analog In #5 is Greater Than/Less than certain voltage, it will activate the virtual output. Under Activation Input listed there, set it to whichever function you created your operator in. See post - for Functions and its Boolean operators > [@V3 Function help](https://community.ecumaster.com/t/v3-function-help/3077/10): > > According bitfileds and check engine you are right. With sensor status it is a little bit different. It is not a bitfield it is an enumeration. So you just use equal, greater, etc. operators. Here is a list off all enums and operators and channels that use it. It will be also available in next build help: Channel(s): Gear shift state \*\* Enumeration\*\* Disabled 0 Not active 1 Rejected - clutch engaged 2 Rejected - gearbox sensor error 3 Rejected - leaver sensor error 4 Rejected - low RPM 5 … --- _[View the full topic](https://community.ecumaster.com/t/new-software-3-044-available/3156)._