# Proform Brushless fans

**URL:** <https://community.ecumaster.com/t/proform-brushless-fans/6574>\
**Category:** EMU BLACK / CLASSIC\
**Created:** [September 25, 2026, 3:20pm UTC](https://community.ecumaster.com/t/proform-brushless-fans/6574 "2026-09-25T15:20:52Z")\
**Posts on this page:** 5\
**Page:** 1

<div class="post-metadata">

**Author:** ![gctech](https://avatars.discourse-cdn.com/v4/letter/g/e480ec/32.png) [@gctech](https://community.ecumaster.com/u/gctech)\
**Post date:** [September 25, 2026, 3:20pm UTC](https://community.ecumaster.com/t/proform-brushless-fans/6574/1 "2026-09-25T15:20:52Z")

</div>

The manufacturer requires a pwm 0-12v positive signal and minimum of 110hz best aproach will be to wire pwm output to H-bridge ?

Thanks

---

<div class="post-metadata">

**Author:** ![matth](https://avatars.discourse-cdn.com/v4/letter/m/f475e1/32.png) [@matth](https://community.ecumaster.com/u/matth)\
**Post date:** [September 25, 2026, 4:56pm UTC](https://community.ecumaster.com/t/proform-brushless-fans/6574/2 "2026-09-25T16:56:49Z")

</div>

A solid state relay should work. +12v and ecu pwm output to relay, then run power to the fan through that.

---

<div class="post-metadata">

**Author:** ![essess](https://avatars.discourse-cdn.com/v4/letter/e/d9b06d/32.png) [@essess](https://community.ecumaster.com/u/essess)\
**Post date:** [September 25, 2026, 6:46pm UTC](https://community.ecumaster.com/t/proform-brushless-fans/6574/3 "2026-09-25T18:46:15Z")

</div>

If you have a free H-Bridge channel, that should work.  
I just browsed the instructions and it looks like it’s an active high signal.

I suspect that this green control line draws practically no current.  
If you can’t afford to give up an H-Bridge channel, you can probably get away with using a strong +12 pullup (470 or so) to the ign on source for the ECU and use a free low-side capable of 110Hz.

---

<div class="post-metadata">

**Author:** ![gctech](https://avatars.discourse-cdn.com/v4/letter/g/e480ec/32.png) [@gctech](https://community.ecumaster.com/u/gctech)\
**Post date:** [September 26, 2026, 1:58pm UTC](https://community.ecumaster.com/t/proform-brushless-fans/6574/4 "2026-09-26T13:58:05Z")

</div>

I do have two H-Bridge available , i was reading also AUX is pulled to 12v

Thanks

---

<div class="post-metadata">

**Author:** ![Billy\_C](https://avatars.discourse-cdn.com/v4/letter/b/278dde/32.png) [@Billy\_C](https://community.ecumaster.com/u/Billy_C)\
**Post date:** [September 26, 2026, 2:27pm UTC](https://community.ecumaster.com/t/proform-brushless-fans/6574/5 "2026-09-26T14:27:14Z")

</div>

I think only one of the aux outputs is pulled to 12v, the one specified for the tach output. Pull-up resistor can be added to any though.
