# Trigger setting Yamaha CP3

**URL:** <https://community.ecumaster.com/t/trigger-setting-yamaha-cp3/4139>\
**Category:** GENERAL\
**Created:** [July 26, 2025, 7:46pm UTC](https://community.ecumaster.com/t/trigger-setting-yamaha-cp3/4139 "2025-07-26T19:46:42Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Lukas\_CZ](https://avatars.discourse-cdn.com/v4/letter/l/bc8723/32.png) [@Lukas\_CZ](https://community.ecumaster.com/u/Lukas_CZ)\
**Post date:** [July 26, 2025, 7:46pm UTC](https://community.ecumaster.com/t/trigger-setting-yamaha-cp3/4139/1 "2025-07-26T19:46:42Z")

</div>

Hi, I’m doing basic setup on a Yamaha CP3 (MT09,FZ09) engine. It’s a three-cylinder engine. I know it has a 24-2 trigger, I’ve already managed to get a good signal on the scope, but I can’t find the correct setting for the first tooth and the sensor angle. You can’t check anything on the engine without disassembling it. Has anyone done something similar?

---

<div class="post-metadata">

**Author:** ![fabryrally](https://avatars.discourse-cdn.com/v4/letter/f/3d9bf3/32.png) [@fabryrally](https://community.ecumaster.com/u/fabryrally)\
**Post date:** [December 29, 2025, 3:12pm UTC](https://community.ecumaster.com/t/trigger-setting-yamaha-cp3/4139/2 "2025-12-29T15:12:53Z")

</div>

did you solve your issue?can you share the scope?