I think the alternator controll may need some improovements….First one is the base DC doesnt work, strategy doesnt use PWM1 table nor base DC from Alternator Parameters menu [image]

I verified and alternator control strategy works as expected. It doesnt use PWM table values. It just uses PWM oputput functionality and assigned output [image]

Thank You Jakub! But Did you check also inverted output strategy? Can You see I set 70% as Base DC and still get 50% on engine startup what produces 15+ volt spikas that may damage my li-ion battery…also DC if inactive From PWM1 Parametes menu doesnt work to me still get 0% if inactive

No parameters from PWM setup except frequency and output work. I will take a look for inverted output.

Allringt but the Base DC from Alternator parameters menu may work for cases once PID no active as on startup?

When the engine is not running 100% PWM is applied (or 0% if you invert the output). I think it is a problem. For next build 3.061 it will be changed. When the state will inactive or cranking, the PID will be disabled, and the base DC will be applied to PWM output.

Great appreciate that :slight_smile:

Hi, I am currently trying to achieve alternator control on a Mazda NC 2.0 engine with Mitsubishi alternator . I have tried different outputs to control the regulator, but with no success …. it seems that this regulator need too much current that the different outputs can’t control ( even H-bridge,…

Try to look this topic: [image] Miata alternator help EMU BLACK / CLASSIC I have a nearly stock 1.8vvt NBFL running with these settings without issue, so I would assume this would be correct. Let me know how it works for you! smiley

Hi , I’ve read this topic before to ask for help :wink: I’ve tried a similar setup on Black V3, with H-bridge output, and the result is that it seems to pull too much current, this cause the ecu to shut this output ??? If i do off/on I have a nice signal again on this output …. So to prevent from …

I never seen alternator requires high current to controll…must be HW or SW issue…post alternator type, config, drawing etc and maybe we figure out whats wrong

V3 - Alternator Controll

V3 SOFTWARE

Jadzwin_ECUMASTER December 16, 2025, 10:02am 9

Try to look this topic:

Topic		Replies	Views
Alternator Control 5V PWM EMU BLACK / CLASSIC	7	2365	February 10, 2024
Alternator Control: Table-Based Pre Control EMU PRO	3	237	August 20, 2024
Miata alternator help EMU BLACK / CLASSIC how-to	10	690	January 24, 2025
5V PWM Alternator quick how-to GENERAL	0	208	December 23, 2025
EMU Classic Outputs EMU BLACK / CLASSIC	1	102	July 5, 2026

V3 - Alternator Controll

Related topics