Gear calculated and CAN Wheel speed issue

EMU BLACK / CLASSIC
1

Hello,

I’m trying to configure my EMUblack to calculate the gear based on the CAN wheel speed.

Based on the doc, I should config for each gear the gear ratio from log, but unfortunately it s always 0. :confused:

Is there any specific config to be able to use this feature with can wheel speed?

Thx

Hereafter my current config and a log where we can see no gear ratio at all.

no_gear
no_gear672×716 41.4 KB

FW Version : 2.175

2

Resolved

FYI, the pb was the clutch pedal sensor.

Ecumaster support was super helpful. :+1: