Hi! I’m currently working on my own digital dash. Right now it works with an EMU Black but I’d like to extend it’s code to support the EMU Pro. Is there going to be a detailed description of the standart EMU PRO CAN Protocol, or a .dbc file, to for example support it’s additional measuring channels?
Thanks!
Hi,
We will be adding a new CAN stream dedicated to EMU PRO, and when it happens, CANX and DBC files will be available. There is no timeline for it yet.
Currently, you can enable EMU Black stream in EMU PRO, and any additional values you need, you have to send with custom CAN export.
Hi. is this sorted asking because I can’t seem to find it
Hi,
Not yet. We were busy with the DI.
However, since the most significant part of the DI development is done, we are returning to implementing everything that was put back because of it.
Following up on this request. Is this available by any chance?
EMU Black V3 i have custom dash panel where is readed and showing data from EMU now i have problem with AFR in EMU i correctly see 25AFR during decceleration but ony my display still SHOW 7.5 its possible to share DBC file for can i think there is any change
Thank you
Which ECU are you asking about, EMU BLACK or EMU PRO?
What firmware version are you using in your ECU?
I’m attaching the DBC file, as both ECUs use the same protocol:
emu_black.dbc (5.5 KB)
Emu black SW V3.072
looks like value on can stream is different i only read can message base on DBC file during decceleration afr value 7.5 in ecu afr show 25.5
There is no AFR signal in the DBC file, only lambda.
Could you please provide the exact name of the signal from the DBC file that you want to read?