Idle control - HOW TO

[konrad]

When Active (IDLE) it works good. The problem I have is when IDLE is inactive and the engine is cold. I miss a table like in V2 where I could set IAV opening % based on CLT (that would work when IDLE is NOT active).

For reference discussed a bit here as well:

Idle and warm up tuning

Altering the active state airflow table seems to be helpful. When cold I brought the values up to be close to the cranking IAV DC and the engine starts. There is still the bump down visible, but the engine continues to run and warm up. For sure I need to adjust the IGN PID and the values for IAV in the active state airflow table to match the desired RPM (target) so the PID would not introduce to much change on either direction. [Zrzut ekranu 2024-08-12 o 11.02.19]

Just nailed down now to the moment when Idle is not Active.