Idle problem, Active state air flow not showing the right RPM

V3 SOFTWARE
1

Hello,

I found an issue with the idle, while cursing at high gear low rpm 1-2k car will remain in Idle.

I will attach logs and file, i don’t know why the care behaves like this.
Steps to recover some revs until 5-6k.
I have a function that deactivates overrun under 2%pps after 1.5 s
In first log : “BUG IDLE” issues is at 38:40->41:20

Log idle bug
Log idle bug1475×807 146 KB

BUG IDLE.emublog3 (3.0 MB)

Bug idle 2.emublog3 (2.2 MB)

20260614_2329_19.emub3 (69.6 KB)

2

Attach your MAP too please.

3

Done, I don’t know why was not attached. Thank you

4

The log attached finish before 38:40. Could you point the time on the log with the issue ? And describe exactly what is a problem, what help a lot during analyzing

5

Hello, sure, sorry the timezone was like this :
30:15 → issue not pressent all look fine :

image
image1605×946 135 KB

Then the issue appears from : 30.38 till here :

image
image1683×941 88.4 KB

Around 31:70, after the rev the idle came again to normal idle around ~900 rpm

6

Vertical axis in this table is idle target rpm not rpm