Hi,
Could someone give me a basic explanation on how to set up knock calibration with EMU PRO ?
I fell in the mist …
For the frequency, I have used 1800/(pi x d )
But for the gain ???
What kind of signal level should I aim ???
I have searched for a raw signal input, but seems that it doesn’t exist ?
In fact I am using an original harness with 2 sensors in one connector, and I am unsure wich is N°1 and which is N°2, and I don’t see a way to be sure of that…
Please give me some light on that topic
Kind regards
P.S. excuse me for my poor english 