Hello i have some problems with my setup. After many corrections my cars run, but i leave without saving changes and lost anything, now wont start.
Short info
2.3l 5 cylinders
COP from audi R8
Bosch 627cc ev14
4bar map (external mounted on intake manifold)
TB drive with cable and TPS
LSU 4.2
Primary trigger VR
Second trigger hall pulluped 10k
Crancking fuel 4-5ms
VE table 42-44 kpa on idle 1100rpm
This is the settings after firts i can see, but i am leave…
I am cheked with light gun and set ignition and cranchking anle 0°
First trigger 8 - 4 - 1 - 0
Trigger angle 50- 72- 90- 98
Both trigger settings show timing correct with is the best. And i checked trought cranck sensor hole my TDC comes with 19tooth after missing
Some one help me.
