Please enter your opinions here, what you like, what you don’t like, suggestions for improvements, etc.

Please post log and base map. It is hard to say why it doesn’t work looking just at a screen. I’ve test fuel cut on the bench and it works ok

Everything works as it is set up. Your fuel cut is defined at 7450 and it is performed then. It is normal that the engine can rev a little bit higher in such situation. Your rev limiter is set to 7800 so it doesn’t work (it always must be set lower than RPM fuel cut). Rev limiters are the proper …

Instead of putting this in the 3.033c thread I will keep it in the general thread now. I know you have tested the Acc Enrich/Correction on the bench and it works for you… but can you possibly explain the numbers I am seeing? This is on FW 3.035. I have attached a short log, complete cold start up …

[image] Acceleration enrichment on v3 emu black V3 BETA TESTS Acc enrichment is a little bit more complicated in calculations as just the value from table. If you constantly accelerate the added fuel is summed (it is simplification because the algorithm is more complex). S…

As derUltraTT wrote, it is a litle bit more complex and if you constantly accelerate the throttle the ACC enrichment need to cummulate. However I found small bug when acceleration enrichment is small (less than 15%) and it is your issue. Here is a firmware with the fix: https://www.ecumaster.com/…

VERY minor bug I noticed when using the “TC active indicator output” with a simple LED. With the below settings, when stationary or <8-10kmh, the LED is very slightly glowing when it should be turned off. When you start driving, it turns off as it should. If you untick “Activate TC output when TC d…

I have tested this today and it is working well now :+1:

Software opinions

V3 SOFTWARE

derUltraTT September 14, 2024, 7:42pm 551

Topic		Replies	Views
New software 3.047 available! V3 SOFTWARE	185	4423	July 29, 2025
Version 3.063 BETA V3 SOFTWARE	74	3437	April 18, 2026
Version 3.060, Release candidate V3 SOFTWARE	49	2056	January 15, 2026
New software 3.043 available! V3 SOFTWARE	79	4381	June 13, 2025
New software 3.057 available! - new "fast" rev limiters, launch control, rolling start V3 SOFTWARE	100	3773	October 31, 2025

Software opinions

Related topics