Wanted the check the following is correct, I noticed when I lift of the PPS 100% to 0% the DBW is being taken from the Idle, where I thought it would be taken from the DBW table until the conditions for idle are met.
I realise that this is possible because in the Overrun settings I do not have the override dbw section selected.
However in idle parameters Idle is only on if Map over 25kpa.
I have added in some Overun DBW %’s now, which has also made me notice there is no overrun fuel, just complete fuel cut, what % fuel cut is normal?
Oulton Park Log 2025.emublog3 (1.2 MB)
E46 V3 EFI 7.6 Oulton.emub3 (69.3 KB)