V3 Rev limiter Hysteresis

[ATSAustin]

This is the same issue I have discussed in another thread. I agree that this should be customizable by the user. The previous strategy was great. Personally I would take the previous strategy and just add a programmable cut start value.

Version 3.059 Release Candidate #2

Thanks for looking into this. Glad to see fuel cut % has been added back to the log for rev limiter. Here’s a log with FW 3.053. Note a couple things - lambda goes lean as fuel cut % increases interpolation begins immediately on activation of limiter RPM is smooth! This engine seems to stop accelerating at about 50% fuel cut, and therefore does not reach target - this is fine! [image] Now here’s a log with FW 3.062. Limiter goes active 400rpm before target. Fuel cut % does not increase u…