Version 3.059 Release Candidate #2

[ATSAustin]

Thanks for looking into this. Glad to see fuel cut % has been added back to the log for rev limiter.

Here’s a log with FW 3.053. Note a couple things -

• lambda goes lean as fuel cut % increases
• interpolation begins immediately on activation of limiter
• RPM is smooth!
• This engine seems to stop accelerating at about 50% fuel cut, and therefore does not reach target - this is fine!

Now here’s a log with FW 3.062.

• Limiter goes active 400rpm before target.
• Fuel cut % does not increase until we are within 100rpm of target.
• Nearly immediately goes to and flattens at 38% fuel cut.
• RPM bounces.